Euro fence installation is not very complex. It’s not like other kind of fence need to be installed set by set. Setting up the euro fence will be several sets installed together.
1.Measure the length on the ground, normally is 15m or 30m same length as the euro fence roll. We make 15m length of euro fence as an example. Dig holes every 3 linear meter. Need to make sure the line of these holes are straight, we can not change the direction after setting up the swallow tail post.
2.Setting up the swallow tail post into the holes in every 3 linear meters and fill the earth into the edge of the holes. Need to make sure the swallow post is strong enough and won’t move even we try to move it.
3.Open the euro fence roll to a 15 linear meter straight panel and stand it up.
4.After standing the euro fence panel up to the post, set up the U clips with a special tool which Skyhall will provide with the fence. Make sure the U clips are locked the vertical wire of the fence panel on to the swallow tail post. The distance of the U clips are 200mm ~ 300mm according to different height.
5.Install the post rain cap on the top of the post in the end. If the height of euro fence is difficult to touch the post top, please install the post cap first before we set up the post.
If calculating the distance of post carefully, it is possible to dig all holes first, then setting up all euro fence panels next. This will increase the installation speed a lot. If the ground is concrete instead of earth, we need to use the swallow tail post with flange plate, installing the post with anchor bolts in to the ground.